When using the Nginx web server, server blocks (similar to virtual hosts in Apache) can be used to encapsulate configuration details and host more than one domain from a single server. Step 5 – Setting Up Server Blocks (Recommended) You have now learned basic management commands and should be ready to configure the site to host more than one domain. To re-enable the service to start up at boot, you can type: If this is not what you want, you can disable this behavior by typing: To do this, type:īy default, Nginx is configured to start automatically when the server boots. If you are only making configuration changes, Nginx can often reload without dropping connections. To stop and then start the service again, type: To start the web server when it is stopped, type: Now that you have your web server up and running, let’s review some basic management commands. If you are on this page, your server is running correctly and is ready to be managed. You should receive the default Nginx landing page: When you have your server’s IP address, enter it into your browser’s address bar: your_server_ip If you do not know your server’s IP address, you can find it by using the tool, which will give you your public IP address as received from another location on the internet: INSTALL JITSI MEET UBUNTU 20.04 SOFTWAREYou can access the default Nginx landing page to confirm that the software is running properly by navigating to your server’s IP address. However, the best way to test this is to actually request a page from Nginx. ├─2369 nginx: master process /usr/sbin/nginx -g daemon on master_process on Īs confirmed by this out, the service has started successfully. Loaded: loaded (/lib/systemd/system/rvice enabled vendor preset: enabled)Īctive: active (running) since Fri 16:08:19 UTC 3 days ago
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |